Skip to main content

HTML5 Crestron Control System Configuration

Scope: Crestron equipment configuration, independent of the AVstudio editor. These settings apply to HTML5 Web XPanel deployments on supported 3-Series and 4-Series processors.

Check the processor and firmware​

Connect to the processor's console using Crestron Toolbox or SSH and inspect:

ver -v
ssl
authentication
userpageauth

Crestron's HTML5 Web XPanel dependencies list firmware 1.7000 for 3-Series and 2.500.x for 4-Series as the feature baseline. Use the supported firmware for your model; token-based clients can have additional requirements.

Authentication settings​

Processor configurationRequired settings
3-Series, FORCED_AUTH_MODE falseSSL must use Self or CA; authentication must be on
3-Series, FORCED_AUTH_MODE trueSSL and authentication are enforced; user page authentication must be on
4-SeriesSSL and authentication are enforced; user page authentication is recommended for browser Web XPanel login

Where authentication is configurable and currently off, enable it with authentication on. Use userpageauth on where indicated above. Source: Crestron Control System Configuration.

Projects hosted outside a 4-Series processor​

For browser Web XPanel projects served by a separate web server or development workstation, inspect the shared-session setting:

webserver allowsharedsession

For that hosting arrangement, Crestron specifies:

webserver allowsharedsession on

This is a hosting-specific setting, rather than a command to apply to every installation. The authentication table above describes browser Web XPanel; other clients can specify a different procedure. Follow the documentation for the client being deployed.